Using a Headlight Modulator

This Autoswitch is triggered by the digital voltage from the Turn Signal Cancel button on BMW motorcycles 2005 and newer so there is no interaction at all between the headlight or high beam lights.

Using a Turn Signal Canceler

CAN-BUS BMW bikes series R and K have included the signal cancel feature and anything else should not be used..

Using Multiple Autoswitches on the Same Vehicle

An AS6B and an AS6B2 can be wired to the very same conenction points on the bike. However one AS6 will control one relay and the other AS6B2 is wired to the second relay. Now dual operation can be had. Two quick taps operate the AS6B2 and a single longer button hold activates the AS6B!

LED Indicator Light Information

This LED has a lens on top. The housing is a 5mm diameter, 7mm tall. There is a 1mm long flange at the bottom thats 6mm diameter. The wire underneath needs aproximately 20mm before a full bend can be made. This stiffness is only due to all the layers of protective heat shrink tubing. By modifying this area the bottom of the LED wire secion can be set up much smaller.

The LED is a bi-color. Red or Green. It changes color by getting the volatge on the feed wire reversed by the processor. When the LED is quickly pulsed the color appears orange to the eye. The wire is 6 to 7 feet long. It should never be cut or altered due to the danger of damaging the processor chip. If the wires are shorted when the Autoswitch is powered up, the processor chip will be instantly ruined.

Further tech info about converting the LED to be a bulb, or changing to a different LED entails custom work, info and configurations we do not have available at this time.